Starter Comparison

IMI-Hi-Torque � vs. Hitachi Type
SOLENOID DESIGN
The solenoid of the Hi-Torque unit is enclosed in aluminum coupled with a vent hole enabling the unit to dissipate heat more rapidly or breathe. Equally important is knowing a half cup volume of air which is circulated when solenoid is energized.	Solenoid is tightly encapsulated in steel. When the starter is near the exhaust system or headers it is often subject to the Hot Start syndrome.
TORQUE
Provides in excess of 525 ft. lbs. of torque.	Provides approximately 425 ft. lbs. (25% less!)
GEAR RATIO
*Hi-Torque* has a 4.44 to one gear ratio.	Other type 3.75 to one gear ratio.
PHYSICAL DESIGN
IMI is the only unit recommended by one of our countrys leading manufacturer of performance exhaust system or headers. Hi-Torque provides the end user with maximum starter and header clearance.	This type of unit cannot boast this feature.
CURRENT
Under exact load conditions the Hi-Torque unit draws less current than competitive units.	Draws more current than IMI type.
RE-INDEXING (POSITIONING)
To re-index or change the position of the Hi-Torque unit there are three allen head bolts on the front of the unit. Remove these and simply rotate and replace the allen heads.	To reposition requires partial disassembly of the unit and is a much more difficult and complex job for the end user.