Winter Rebuild

Idler Bracket w/ Outboard Support

For Immediate Release
Jan. 30, 2014

Racers with large superchargers or high overdrive ratios tend to flex the standard idle pulley bracket. This leads to excessive belt & pulley wear. A solution is the addition of an outboard support to prevent any flexing. Good Vibrations Motorsports offers this assembly complete with the options of different width idler pulleys. Machined from billet 6061-T6 aluminum and designed for severe competition applications. Our longer slot also gives a wider range of belt tension than blower mounted brackets. Available for: Big Block Chevy, HEMI, TFX, BAE and most KBs.

Contact: Good Vibrations Motorsports, 8858 Painter Ave, Suite E, Whittier, CA 90602. 800/576-7661


Copy Picture for Hi-Resolution Images (For Printing)


Press Releases Archive:

GVM Tire Covers
B&M Style Shifter Cable
Piston & Rod Installer
Billet Injector Throttle Bracket
Single Gauge Leakdown Tester
Valve Cover T-Handle Wrench
2017 GVM Catalog
Spark Plug T-Handle Wrench
Burst Panel Deflector
2015 GVM Catalog
Burndown Breathers
Crank Hub w/ V-Groove
March Meet Bonuses
IHRA 2015 Sponsorships
Title Sponsor for the March Meet & SNN
Electronic Lean-Out Valve
2014 Catalog
Stainless Steel Carb Plumbing
Sleeve Puller
Idler Bracket w/ Outboard Support
25th Anniversary
Hemi Valve Covers
Hemi Gear Drive
Precise Timing Pointers
Front Offset Drive
Injector Air Filter
Crank Trigger
Over Center Bracket
Kill it with Big Red
Primer Kit
PR Push Rod Checker
Piston Racks
Throttle Stop
The Plug Gapper
Bypass Pill Driver
Injector Throttle Bracket
Blower Belt Guards
Engine Diapers