Blackout Series

EZ-On Hose Press

Up AN Tools Koul Tool Tech EZ-On Hose Press Leak Down Tester Ring Compressors Pit Mats Tool Trays & Racks

Hose Assembly the Easy Way
(Click Here for PDF)

The EZ-On Hose Press Introduction and Instructional Video

KOULtools EZ-ON Hose Press

The EZ-ON Hose Press is stored in a custom moulded case. 
All the fitting adaptors required for -4 thru -16 are stored within the case.

The kit must be stored as shown for the case to close properly.

KOULtools EZ-ON Hose Press

The extended jaws are for sizes -4 thru -8 hose.
 

KOULtools EZ-ON Hose Press

The short jaws are for sizes -10 thru -16 hose.
 

KOULtools EZ-ON Hose Press

The chart on the bottom of the case matches the color of the adaptors to the size of the fittings.The adaptors are also marked with the dash numbers. The pinned adaptors are used for angled fittings.

KOULtools EZ-ON Hose Press

Place the proper adaptor in the fitting jaws.
Align the pins and push in straight. 
SEE THE PHOTO.

KOULtools EZ-ON Hose Press

For straight fittings, 
use the round adaptor as shown.

KOULtools EZ-ON Hose Press

To remove the adaptors, 
use a pin punch or similar as shown.

KOULtools EZ-ON Hose Press

Install the fitting as shown. DO NOT OVER TIGHTEN. Some brands of fittings will require a looser clamp to line up the hose. Hold the fiting in place till you get the hose started, then tighten the clamp.

KOULtools EZ-ON Hose Press

Clamp the hose in the jaws, leaving enough hose exposed so that the hose can be fully installed on the end of the barb without interfering with the clamp.

KOULtools EZ-ON Hose Press

IMPORTANT! 
Oil the barb and hose before installation.

KOULtools EZ-ON Hose Press

A hose clamp jaw is removed to expose the carriage stops. If the carriage hits the stops, retract the hose clamp carriage and reclamp the hose. Do not over tighten the carriage against the stops.

KOULtools EZ-ON Hose Press

Straight fitting assembly shown here.
 

KOULtools EZ-ON Hose Press

A few fittings manufacturers make their fittings with a tight radius. In this case, remove the plastic adaptors and clamp as shown above on right (without the adaptors.)  A little practice and you will get the procedure.

Keep your EZ-ON Lubricated
 

Click here for more info or to purchase the Kits  

 

 

Bottom Border

Toll Free: 800/576-7661
Email: sales@dragparts.com
"Our Ultimate Goal is Your Success"
Good Vibrations has Been Empowering Racers Since 1989

Search | Site Map | Performance Products | Pre-Owned Parts | Technical | Photo Gallery | Special Events | Contact Us

We STOCK the following performance race products: Aeromotive, Billet Connection, The Blower Shop (TBS), Control Cable, Deist Safety, DJ Safety, Enderle Fuel Injection, FAST-EFI, FIE, IMI Hi-Torque, JAZ Products, JESEL, Lucas Oil, Mallory Ignition, Milodon, Prolong, RCD Engineering, RePlay, SCE Gaskets, Smiley Headers, System 1 Filters, Total Seal Rings, Wilwood and XRP Plumbing.  

Building a better world for children

Wish to join the Good Vibrations World Vision team? Click here